RS 250 MK – MIG/MAG Welding Machines
- Operates with 3 Phase 400V-50/60 Hz mains voltage and generators, tolerates voltage fluctuations up to 15%.
- Excellent welding characteristics with all types of solid and flux cored wires with CO2 or Mix gases.
- Compact wire feeding units are standard.
- 4 roll drive system offers good feedability with long torches and offers less deformation on soft wires such as aluminum and flux cored wires.
- Optimum welding parameters can be obtained from the printed table inside of the wire feed cover.
- Wire feed speed and 2/4 trigger adjustments are on the front panel, Soft Start, Pre-Gas, Post-Gas, Burn-Back timer settings, manual wire feeding & gas valve buttons are inside of the wire feeding cabinet.
- Welding voltage is adjusted from the course and fine switches; increments are optimized to obtain welding parameters with lowest spatter levels.
- Digital displays on the power source for adjusting and monitoring of welding parameters.
- Multiple workpiece connections (Inductance outlets) enables optimum parameter adjustment for low spatter welding.
- ø300 mm, ø270 mm and ø200 mm spools and drums of any size can be used.
- 220V AC outlet for CO2 gas heater.
- Built in gas cylinder platform with large wheels to ease mobility in workshops.
- Fan cooling and thermal protection against overheating.
| Power Source | ||||
| Mains Voltage (3Ph) | 400 | V | ||
| Input Power | 10 (%40) | kVA | ||
| Input Current (Eff.) | 9.2 (%40) | A | ||
| Welding Current Range | 57 - 250 | A | ||
| Nominal Welding Current | 250 (%40) | A | ||
| Open Circuit Voltage | 19.7 - 51 | V | ||
| Voltage Adjustment Steps | 3 x 7 | |||
| Dimensions (l x w x h) | 890 x 460 x 950 | mm | ||
| Weight (Net) | 105 | Kg | ||
| Protection Class | IP21 | |||
| Wire Feeder System | ||||
| Welding Wire Diameter | 0.60 - 1.00 | mm | ||
| Standard Roller Groove Size | 0.80 - 1.00 | mm | ||
| Wire Feeding Speed | 1 - 24 | m/dk | ||
| Torch Trigger Control | 2 / 4 | |||
| Spool Capacity | 20 | Kg | ||
